Uploading and Loding Picture ...(0/1)
Pocho35 AR lvl.2 Flight distance : 84170ft + Add FriendPerson Message Argentina Offline | |
2023-7-17 Use props |
Sean-bumble-bee Core User of DJI Flight distance : 15997ft
+ Add FriendPerson Message United Kingdom Offline | |
2023-7-17 Use props |
Pocho35 AR lvl.2 Flight distance : 84170ft + Add FriendPerson Message Argentina Offline | Sean-bumble-bee Posted at 7-17 08:06 In this case there is no problem with the SD card, since I removed it, I just want to know the meaning of the red-green flashing, and why on certain occasions it works as it should, and so far there is no answer.... I guess those who wrote the firmware command lines know what it means, since the drone does not have artificial intelligence... Greetings. |
2023-7-17 Use props |
Sean-bumble-bee Core User of DJI Flight distance : 15997ft
+ Add FriendPerson Message United Kingdom Offline | |
2023-7-17 Use props |
DJI Gamora Administrator + Add FriendPerson Message Offline | |
2023-7-18 Use props |
Pocho35 AR lvl.2 Flight distance : 84170ft + Add FriendPerson Message Argentina Offline | DJI Gamora Posted at 7-18 00:12 Yes, I also have a mini SE that I bought when the mini 1 failed, and so far it works fine. From time to time I test the mini 1 and a few days ago it connected normally, and I used it in a short and low flight doing it normally, I turned it off, I kept very happy for the return to normal , but it did not last long, the next day, it failed again... Thank you |
2023-7-19 Use props |
DJI Gamora Administrator + Add FriendPerson Message Offline | Pocho35 AR Posted at 7-19 15:01 Hi, Pocho35 AR. Thank you for the reply. When the aircraft status indicator blinks red and green alternatively, it indicates that the drone is in GPS mode. If the motor can be turned on, the drone is in the Altitude zone/Warning zone. If the motor cannot be turned on, the drone is in a Restricted zone. For the issue with the RC, can you please provide the error on the DJI Fly? If you could also provide a video showing the issue, that will be much appreciated. Thank you. |
2023-7-22 Use props |
Pocho35 AR lvl.2 Flight distance : 84170ft + Add FriendPerson Message Argentina Offline | DJI Gamora Posted at 7-22 04:21 Hello again, in the app, it does not show any errors, it just does not recognize any aircraft, and it gives the steps to connect, but without any result. As for the leds, in the user manual, there is no green-red flashing slowly.... I attach an image. Thank you
|
2023-7-24 Use props |
DJI Gamora Administrator + Add FriendPerson Message Offline | Pocho35 AR Posted at 7-24 16:47 Hi, Pocho35 AR. Yes, it is not in the manual but the information provided above was confirmed by our relevant team. Can you please provide a video showing the issue for further checking? Also, please provide the firmware versions. Thank you. |
2023-7-26 Use props |
Akash Bhardwaj lvl.1 + Add FriendPerson Message Hong Kong Offline | |
2-27 06:39 Use props |
djiuser_bjH8ACRXGM7m lvl.1 + Add FriendPerson Message Spain Offline | Hello Pcho35 AR. Here same problem, not connecting and green / red slow flashing light in a Mavic mini. After trying many things, I discovered that the problem is "heat". I put the drone in the freezer (yes, only for a few minutes) and it worked for a minute or two. After that same problem. I repeat the procedure many times, the drone works when it is cold. By the moment I haven't a permanent solution, keep trying. I hope it helps someone |
7-19 04:26 Use props |
Pocho35 AR lvl.2 Flight distance : 84170ft + Add FriendPerson Message Argentina Offline | djiuser_bjH8ACRXGM7m Posted at 7-19 04:26 Hello djiuser_bjH8ACRXGM7m, thank you for sharing your experience, yes, I have heard that some electronic elements are "fixed" with intense cold, it could be a defective element, or some solder that has come loose, and when it contracts with the cold, it makes contact again , I am not an electronic technician, but you would have to compare voltages in different parts of the motherboard, before and after, to discover what is failing, possibly the transmission module. Thank you again, and I hope you find and share the definitive solution, many DJI drone users will thank you. |
7-19 07:03 Use props |