How to Choose the Right HDD Drill Bit - FIRMTECH (2024)

With many choices available today, selecting the proper HDD drill bit for a particular application can become quite confusing.

There are spade, drag and shear type bits, point attack bits, PDC bits, milled tooth and TCI (tungsten carbide insert) roller cone bits. There are IADC codes, soft, medium, and hard categories for each bit, sealed, non-sealed, roller, and friction bearings. The list goes on forever.

What is a contractor to do when the success of the drilling operation is directly related to what is screwed on the end of the drill pipe? In an effort to simplify the process, I am going to suggest a simple, systematic approach. This process involves a few simple steps and will get you in the ballpark every time:

• Identify – Soil/Rock type(s)
• Classify – Soil/Rock category
• Choose – HDD Drill Bit type within the category
• Optimize and Adjust – Operating parameters/subsequent selection

• Perform a site (or sight) survey. Sometimes actual geology is exposed from pre-existing road work, other construction, or through onsite potholing.
• Contact the the relevant authorities for geology specific/soil surveys to a location.
• Contact local water well drillers.
• Contact local construction companies.
• Contact tooling suppliers/manufacturers, they may provide information related to past experiences in specific areas.

• Talk to suppliers and manufacturers of these products. They can provide recommended operating parameters and guidelines for optimal use.
• Noting and identifying cuttings return characteristics while drilling can help in refining ongoing utilization and selection.

• Rig operating limits can influence bit selection.
• Torque requirements become greater in softer
• materials.
• WOB (weight on bit) requirements become greater in harder materials.
• Sealed, friction bearing, roller cone bits are preferred for fluid applications. However, open bearing roller cone bits are used successfully on shorter bores of less than 200 ft.
• TCI roller cone bits with round top shaped inserts will produce the slowest ROP (rate of penetration).
• Maximum gage, shirttail, (skirt) and leg protection is a must for roller cone bits.
• Your rig operating cost investment outweighs the cost of a drill bit. Choose a bit that produces the most cost effective balance of ROP and total run time. Trip time is costly – improved ROP equals less drilling hours and money spent.
• Conventional “petroleum” roller cone bits are not always best suited for HDD.
• Certain bits, designed specifically for HDD, can prove to be more cost effective.
• Re-run roller cone bits are “used bits.” No one can tell you how used they are. These bits are considered a risk and discarded by petroleum operators. Consider the investment in your bore and weigh the risks.

The article is original from ” TRENCHLESS Technology“