Use Bobcat Diagnoser to diagnose your Bobcatminer.
Sometimes it’s not your side, it’s the Blockchain.
If your beacons looks like the image below, that means your Miner tried PoC but failed. Basically in this case, your miner should be relayed or behind a strict firewall.
If you have had Beacons before but it disappeared recently although you still have a lot of Witnesses, it may caused by the Network Firewall even you opened port 44158. It is possible that your hotspot starts to send out beacons again after restarting / reseting your ISP modem / router, or rebooting your router.
If it disappears again after rebooting/reseting, it may caused by Packet Filter Rules which filters the packets from/to your Miner. Try to add pass rules or disable deny rules to make packets pass. See Network.
It’s also possible that your ISP company banned traffic from/to your Miner from their side. In this case, you need to change your IP address but that’s not easy. Also some routers have port forwarding issues can also cause this problem.
If your Miner has good network settings but didn’t sent out a Beacon from the beginning, maybe your Antenna / Pigtail is broken. See Bobcat Antenna Repair.
Your hotspot is not sending out beacons but you still have a lot of Witnesses. It is very hot and it has been connected by too many Miners. Basically in this case, I think you can give up, your witness income will be Good Enough. 😀